GEOLOG can offer a complete set of carbon isotopic analyses at well site, thanks to an innovative patented analytical solution. GEOLOG was the first company able to perform isotopic analyses up to propane and including CO2 at the well site. The value of which is having a continuous log throughout the well for increased gas characterization, and reducing risks incurred through conventional isotube collection, in real time.
Chemical analyses of gas compositions are fundamental, but sometimes these data are insufficient to fully understand gas origin, maturity and distribution.
For example, gas occurrence in the cap rock can be better explained by using isotopic data, allowing operators to understand if gas is indigenous or migrated from a reservoir, through slight but continuous leakages.
The frequent sharp increase in the isotopic value entering from the cap rock into the reservoir can be interpreted as an unmistakable signal of gas bearing levels, if supported by an increased concentration of gas.
To understand the origin of gas, GEOLOG provides various models validated on case histories and based on integration of chemical and isotopic values.
By studying the isotopic data it can be seen that constant values across multiple reservoir zones implies an absence of permeability barriers between the reservoirs as the gases are from similar sources.
The GeoIsotopes service can be used in all phases of the upstream cycle. In exploration it can be utilized to understand the origin of oil, to assess the oil and gas potential of the asset through source rock identification and migration pattern reconstruction.
Moreover if CO2 is present, clear indications about its origin can be given. In appraisal and development phases GeoIsotopes provides data to establish inter-well correlations, confirm interpretations made in exploration wells and to assess reservoir continuity.
The log charts on the left identify different isotopic marking of gases detected at different well targets.
The shallower ones indicate mixing with bacterial gas. Only the lowest interval (the main reservoir target) shows a clear thermogenic origin.
On the right, the crossplots between C1 and C2 isotopic ratio show the extent of migration and alteration of the hydrocarbons.
This is only possible on site with GEOLOG’s GeoIsotope service providing continuous well data and interpretation.